Analog output Magnetic sensor setup

In order to use your Analog output magnetic position sensor with SimpleFOClibrary first create an instance of the MagneticSensorAnalog class:

// MagneticSensorAnalog(uint8_t _pinAnalog, int _min, int _max)
//  pinAnalog     - the pin that is reading the analog output from magnetic sensor
//  min_raw_count - the smallest expected reading.  
//  max_raw_count - the largest value read.  
MagneticSensorAnalog sensor = MagneticSensorAnalog(A1, 14, 1020);

The parameters of the class are

• pinAnalog - the pin that is reading the analog output from magnetic sensor ,
• min_raw_count - the smallest expected reading. Whilst you might expect it to be 0 it is often ~15. Getting this wrong results in a small click once per revolution
• max_raw_count - the largest value read. Whilst you might expect it to be 2^10 = 1023 it is often ~ 1020. Note: For ESP32 (with 12bit ADC the value will be nearer 4096)

Finally after the initialization the only thing you need to do afterwards is to call the init() function. This function initializes the sensor hardware. So your magnetic sensor initialization code will look like:

MagneticSensorAnalog sensor = MagneticSensorAnalog(A1, 14, 1020);

void loop(){
  ...
  sensor.init();
  ...
}

If you wish to use more than one magnetic sensor, make sure you connect their chip_select pins to different arduino pins and follow the same idea as above, here is a simple example:

MagneticSensorAnalog sensor1 = MagneticSensorAnalog(A1, 14, 1020);
MagneticSensorAnalog sensor2 = MagneticSensorAnalog(A2, 14, 1020);

void loop(){
  ...
  sensor1.init();
  sensor2.init();
  ...
}

Please check the magnetic_sensor_analog_example.ino example to see more about it.

Using magnetic sensor in real-time

There are two ways to use magnetic sensor implemented within this library:

• As motor position sensor for FOC algorithm
• As standalone position sensor

Position sensor for FOC algorithm

To use the ensor with the FOC algorithm implemented in this library, once when you have initialized sensor.init() you just need to link it to the BLDC motor by executing:

motor.linkSensor(&sensor);

Standalone sensor

To get the magnetic sensor angle and velocity at any given time you can use the public methods:

class MagneticSensorAnalog{
 public:
    // shaft velocity getter
    float getVelocity();
  	// shaft angle getter
    float getAngle();
}

Here is a quick example for AS5600 magnetic sensor using it’s analog output:

#include <SimpleFOC.h>

// MagneticSensorAnalog(uint8_t _pinAnalog, int _min, int _max)
//  pinAnalog     - the pin that is reading the analog output from magnetic sensor
//  min_raw_count - the smallest expected reading.  
//  max_raw_count - the largest value read.  
MagneticSensorAnalog sensor = MagneticSensorAnalog(A1, 14, 1020);

void setup() {
  // monitoring port
  Serial.begin(115200);

  // initialise magnetic sensor hardware
  sensor.init();

  Serial.println("Sensor ready");
  _delay(1000);
}

void loop() {
  // display the angle and the angular velocity to the terminal
  Serial.print(sensor.getAngle());
  Serial.print("\t");
  Serial.println(sensor.getVelocity());
}